Speakertek ST-EPI004 Edge Woofers Epicure 2/8

St-epi004 Speakertek Woofer Edge Repair Kits For Woofers Fits All Epicure

Brand: SPEAKERTEK, Type: Foam Kit, Compatible Brand: Epicure-E.P.I. Compatible model : All E.P.I 8 model's, MPN: ST-EPI004, Country/Region of Manufacture: USA, Subwoofer/Woofer Size: 8 Foam Edges fit 8-1/4 E.P.I Frames, Modified Item: No, Non-Domestic Product: No, Custom Bundle: No

SPEAKERTEK ST-EPI004 Description

P foam specifications surround model st-8 ac one diameter for this kit is 148mm - 1mm, 5. We also suggest testing with an audio signal be done by using older used amplifier for your since hooking up any to a shorted blown speaker voice coil can damage. After your inspection if have confirmed that speakers are not damaged, you ready to order the proper parts re-foam woofers and restore them back into useful service. 889, inner diameter 137mm, 5.

We recommend you use the adhesive within 90 days from time receive your kit. Move your speakers to proper work bench and carefully remove woofers from the enclosure making sure mark wires with tape showing polarity or on woofer terminals so that re-installation will be exactly correct, avoid getting out of phase which greatly degrade sound quality, must corrected. Made poly-ether foam surrounds to fit these epicure e. If this joint looks crimped or torn detached from the woofer it must be re-coned replaced with new original used parts available, or upgrade exact same impedance ohms, and general specifications to match existing internal crossover network circuitry.

Made premium grade poly-ether foam surrounds, 1-clear-flex sa100x, adhesive with instructions for all paper cones, 1-detailed photo instruction manual. All kits come with the needed foam surrounds, adhesive, and detailed instructions. This is done by turning your amplifier receiver off and unplugging the power cord wait 15 minutes before unhooking speakers from at rear terminal. You should inspect and test all woofers before ordering a kit.

ST-EPI004 SPEAKERTEK re-foam kits use only top quality high density poly-ether foam surrounds in all of our. 100w, m100, m101, e. If the meter reads open or o. If you hear or feel a springing crunching sound it may be that the voice coil wire windings have been detached from.

Braided lead wires may be fixed if the break is accessible to a soldering pencil. If all of the above testing indicates woofer is not damaged and looks feels to be in good moving condition as stated you should check your woofers with a clean low volume audio signal. Set the meter to read resistance by locating word ohms or Greek letter designation for omega and touch each wired probe from your woofers positive negative terminals.

Adhesives are specially packaged to ensure the proper viscosity. 10 epicure105, m105, m110, a110, e. You can read the dc resistance of a woofers voice coil with standard multi-purpose digital voltage meter. Inspection 1.

In this situation it is much easier to hear abnormalities while listening at low levels with some clean moderate bass frequencies and vocals. Here are some recommended steps: step 1. Speaker systems with 2- woofers. Our adhesives will ensure a solid bond at all of the critical points.

This means there is an open circuit and the voice coil wire broken either at braided lead going into cone or on itself. Inspection 2. Never do this with the on or connected to speakers. These 8 woofer surrounds are.

Lay the speakers on their back facing upward, with woofer cones up and remove front grill. This kit contains 2-8. Made high density poly-ether foam for the standard sized epicure round frames with an outside diameter of 8. Thank you later version each kit contains 2-8.

If not a re-cone or replacement is required. Normal delivery time on priority mail shipments is 2-3 business days or less to most. We warranty all of our kits. This will confirm there is continuity between the woofer terminal and voice coil, that sounds normal at low volume.

We sell no surplus or low grade surrounds of any kind. Take this reading 2-3 times to verify good contact for an accurate. Playing heavy bass without a strong outer surround may cause damage to the woofer, by over stressing lower suspension. 75, outer roll diameter 175mm, 6.

Please check your speakers cone and frame dimensions along with the edge to verify flat attach or straight angled inner edge. Before ordering. Now by gently pressing the cones evenly with all five fingers around dust cap dome that covers voice coil, push cone in and out to make sure it is free moving. If the cone is locked up, or scrapes constantly with resistance and no free space movement can be obtained, woofer cannot re-foamed re-coning or upgrade parts should considered. SPEAKERTEK 8 woofer re-foam repair kit for all e.

Step 3 final inspection. 90, m90, epicure 10, e roll width 13mm, 0. This process should be done carefully to find the sweet spot where woofer coil can felt move freely in its very close magnetic gap without touching. The reading should be slightly lower than average known published impedance, for instance an 8 ohm woofer will normally read between 5-6 ohms or, on meter but considered to have a nominal impedance of.

Check the condition of your woofers, including lower joint inside frame where cone is attached to suspension dampener spider and voice coil, outer diameter 197mm, 7. 511, 1/2 inner attachment - angled our kits are easy to install without shims, and do not require removal of dust caps. Check your woofers to make sure they move freely without scraping, or that are not seized up tight. Our various special adhesives work with paper and all synthetic cones, such as polypropylene, graphite, Kevlar, aluminum, poly-mica, etc.

150, m150, e.

SPEAKERTEK ST-EPI004 Specifications

Identifiers

  • brand: Speakertek
  • mpn: St-epi004
  • sku: 8469874122318291

Specifics

  • type: Foam Kit
  • compatible brand: Epicure-e.p.i.
  • compatible model: All E.p.i 8 Models
  • country/region of manufacture: United States
  • subwoofer/woofer size: 8 Foam Edges Fit 8-1/4 E.p.i Frames
  • modified item: No
  • non-domestic product: No
  • custom bundle: No

351 Ratings (100.0%)

  1. Just as described thanks again AAAA (01-26-19)
  2. Found these as an exact match for my JBLs. Fit couldn't be more perfect. Nice! (01-24-19)
  3. Very well packed, arrived on time. (01-25-19)
  4. A great seller and product (01-19-19)
  5. Great product, amazing instructions. (01-20-19)

Payment

  • PayPal

Returns

  • time: 30 Days
  • type: Money back or replacement (buyers choice)
  • paid by: Seller
  • policy: returns accepted

Offer

  • best offer: false
  • quantity: 98
  • Sold: 0
  • Started: February 2, 2019, 9:27 pm
  • bids: 0
  • ST-EPI004 price: $22.50 USD

General

  • category: Electronics > Components > Speaker Parts
  • availability: In Stock
  • condition: New
  • currency: USD

Shipping

  • cost: $0.0
  • to: Worldwide
  • handling: days
  • type: Flat